Hv cable installation manual

or in cable ducts: If it is necessary to install any of these types of cable in an in-air environment (i.e. a cable pit or cable basement), for short distances, it shall be protected with one of the methods described in EI Protecting 11kV Cables and Joints installed in air from Fire and Mechanical Damage. LV Service Cables. High Voltage Shore Connection (HVSC) Installation: Those onboard systems that are designed to accept high voltage shore power, typically involving incoming power receptacles, shore connection switchboard, step-down transformer or isolation transformer, fixed . T /T! C HV X T /T! CJ HV X X T /T! CJG HV X X X T /T! CT HV X X C CCS Combo standard J CHAdeMO standard G AC connector / kW T AC Socket kW HV High Voltage Signs The following signs are used on the equipment and in this manual: DANGER Hazardous voltage.

INSTALLATION PROCEDURE FOR HV CABLES (IN TRAY) The total cable route shall be inspected to ensure that the routing is complete, as per approved layout and it is coordinated with other services. Size and length of the cables to be checked by the Engineer In charge and Supervisor before cutting the HV cables. This manual (UCIM) formalises the requirements for the safe and efficient installation of all underground cables on Western Power’s distribution system. The specifications, procedures,practices and instructions contained in theUCIM detail the technical requirements to be followed by Service Providers; and act asa reference for auditingand. 8 Safe management of high voltage electrical installations Safe management of high voltage electrical installations 9 3. Maintenance Responsible persons for premises with an electricity supply at high voltage shall ensure that their installation: • safely performs the functions for which it is designed and intended;.

Installation Manual for System , This manual covers storage and installation of nVent cables have been properly sized and the installation. Installation of high voltage cables is described specifically for each panel in the operating. Instructions (see “Connecting high voltage cables” on page 53). *. Installing the serial communication cable for RS SPA/IEC. The installation personnel must have basic knowledge of handling electronic equipment.